Bevel is a traditional beveled laminate countertop edge and countertop backsplash. Although beveled edges and backsplashes for laminate countertops have been around for a few decades, we make ours different. Instead of applying separate pieces of laminate to the faces we use a single piece of laminate and a very precise miter fold to allow the laminate pattern to flow from one face to the other leaving one less seam.
The substrate (backside or base) we use to manufacture our Bevel edge and Bevel Backsplash is MR-50 rated moisture resistant medium density fiberboard (MDF). For our Bevel edges and backsplashes, HPL (High Pressure Laminate a.k.a. the laminate) is hot glued and pressed to the substrate using high strength urethane reactant glue. Both ends of every piece are finished with a 90 degree cut.
All materials used in manufacturing Loti Corp edges are either no or low VOC and all of the surface and seam materials are considered waterproof.
Sizing and Profiles
Our Bevel laminate countertop edging is manufactured in pieces that are 106″ long by 5/16″ thick by 1-9/16″ high. They have a 45 degree beveled face and come with a flat back (FB) mounting surface style.
Our Bevel Backsplash is manufactured in pieces that are 106″ long by 1/2″ thick by 4, 5, or 6 inches high. They have a 45 degree beveled face and top with both folds seamless.
Our Bevel edges and backsplashes can be installed by anyone with decent carpentry skills and tools. The tools and skills needed to install our Bevel laminate countertop edges and bevel backsplashes are common for carpenters and countertop fabricators.
A miter saw and optionally a disk sander are needed to cut to length and miter the corners. Our Bevel edges and backsplashes are composed of MDF and laminate, so no special blades are needed for cutting.
Masking tape and a good waterproof wood glue, such as Titebond® III, are all that are needed for attaching our Bevel edges to the countertop’s substrate. A damp rag is recommended for cleaning up squeeze out glue.
Finally, a good wax surface treatment is recommended if you wish to really make it shine. We recommend PROTECTALL™ Shine Plus. It’s great for the laminate countertop as well.
Loti Corp warrants to the original owner of our Bevel edges and backsplashes, installed by a professional and in a professional manner, that at it’s option will replace this product if it fails due to any manufacturing defect during the first 10 years after initial installation, except for damage caused by excessive heat, physical or chemical abuse, or acts of nature.
The warranty is non-transferable and applies only to our Bevel edges (1) installed by a professional, (2) purchased for use in the United States and it’s territories, Canada or Mexico, (3) which has not been moved from it’s original place of installation, (4) which fails solely due to manufacturing defect.
Loti Corp can not be held liable for failure of any glue lines not produced at time of manufacture. Warranty extends only to replacement of our Bevel edges and backsplashes and does not extend to any labor and/or materials necessary for re installation of the product. Furthermore, Loti Corp shall not be held liable for any loss, direct, consequential or incidental damages arising out of the use of our Bevel edges and backsplashes or any other products manufactured, distributed or recommended by Loti Corp.